Categories
BLOG

pax 2 tips and tricks

Pax Vaporizer Secrets and Tricks – Pax 2 & Pax 3 Vapes NZ

Get even more out of your PAX Vaporizer NZ.

HELENSKINZ NZ

Answer : Yes.

Spin Technique

Holding the Pax 2 horizontally in front of you spin it smoothly three times towards or away from you to change modes. Be careful not to shake the Pax 2, this will not register as a spin and throw your count off. The below modes are listed in the order they show up. It’s easier to count spins in successful cycles of 3 than in total. Therefore Simon is five cycles of three spins, instead of 15 spins in total. If you try to keep count you’ll constantly find that you’ll need to add a few extra spins because it’s difficult to make every spin count.

Party Mode

All four lights are different and cycle through different colors. There appears to be a rhythm/pattern to the color cycle. Lip sensor activation increases speed of color change. Oven is on. Standby timer extended to one minute between sensing movement or lip.

Party Timer

All four lights are stationary. When the Pax 2 is moved the lights jump into a random light configuration, occasionally one or more of the lights are very dim or off. If the Pax 2 is held face down the lights flicker and change rapidly. Lip sensor activation makes the lights flicker and change rapidly for up to 10 seconds. At 10 consecutive seconds of lip sensor activation the lights freeze. Removing your lips and replacing them starts another 10 second flicker display. Oven is on. Standby disabled.

Light Painting

In this mode all four lights show the same color and cycle through colors while the Pax 2 is being moved, when still, the lights are off. Waving the Pax 2 through the air yields a color changing stream of light. The heater can be turned off in this mode by selecting a fifth available temperature, all four lights blue.

Color Carousel

The lights react to movement and position of the Pax 2. When laid flat the Pax 2 shows blue. When face down, an orangish-yellow. When I hold the Pax 2 upright and give it a little circular flick, the colors begin to cycle with a noticeable pattern. The colors can be seen transitioning from one light to the next, as if there is a big globe of colors inside and the lights reflect whichever colors face forward. The heater can be turned off in this mode by selecting a fifth available temperature, all four lights blue.

Simon

Spin the Pax 2 until all four lights flash white three times. The Simon game will begin. Hold the Pax 2 face up, horizontally in front of you. Observe the pattern displayed on the lights, then repeat the sequence by leaning the Pax 2 towards the appropriate light. The heater can be turned off in this mode by selecting a fifth available temperature, all four lights blue.

Funky Town Tone

Pax 2 faintly plays the tune to Funky Town when it turns on. You can hear it if you’re within a few inches of the Pax 2 when it plays. Difficult to hear unless you’re listening for it. To unlock this feature beat a 20 step sequence in the Simon game. The Pax 2 will confirm unlock by flashing the four lights red, blue, green, and yellow and playing the Funky Town tune. To disable the tone simply go into the temperature settings and press the button five times quickly. The Pax 2 will confirm by flashing the four lights red, blue, green, and yellow.

Green Mode

Activating this mode causes the petals to flash a green pattern which moves back and forth. One thing to keep in mind is that you need to roll your Pax 2 three times in the opposite direction to enable it, unlike the rest of the Easter Eggs!

Stealth Mode

Although not technically a secret feature, stealth mode comes in really handy in certain situations so I thought that I’d share it. To activate stealth mode, simply shake your device while its displaying the startup pattern. Stealth mode will keep your Pax 2’s LEDs at a dim white for the duration of your session. To turn off stealth mode, simply turn your device off and then back on. I find stealth mode is great to use while I’m vaping before bed as well as in other places where low light is desirable.

Buy Best Portable Dry Herb Vape NZ.

Check out our Pax 2 and Pax 3 Vaporizers, we always have the latest colors when they are released in USA. Pax is our specialty brand, we have been importing & selling Pax in New Zealand and Australia since 2008.

Buy Pax 2 Vape NZ | Buy Pax 3 Vape NZ

Yes, we still sell Pax 2 and they are awesome! If you want a Pax and can’t afford a Pax 3, do not fear, the Pax 2 is still a great vape to buy. Highly recommended by Helenskinz.

Get even more out of your Pax Vape NZ. Unlock all the hidden features in your Pax Vaporizer. Spin Technique Holding the Pax horizontally in front of you spin it.. all the secrets revealed! Helenskinz NZ your Pax Specialist.

How to Use a PAX 2: Instructions, Tips, Details & More

Read These PAX 2 Instructions Before Using Your Personal Vaporizer:

The PAX 2 personal vaporizer is beloved for its sleek style and smart construction. Thoughtfully designed for the discrete consumer, PAX 2 simply doesn’t look like a vaporizer, opting for a streamlined anodized aluminum body. Reduced odors and a remarkably small and light size allow for low-key consumption on the go.

Before breaking out your personal vaporizer, it’s important to understand the ins and outs of how to operate your device. This quick how-to guide takes new and experienced consumers alike through the vaporization experience from start to finish.

What’s in a PAX 2 Box?

PAX 2 includes everything needed to use your personal vaporizer right out of the box. These items include:

  1. The PAX 2 personal vaporization device
  2. Standard Oven Lid
  3. Elevated Mouthpiece
  4. Flat Mouthpiece
  5. Maintenance kit with pipe cleaners and wire brush
  6. USB charger and 2-foot charging cable

Start Using Your PAX 2 in These 5 Easy Steps

Get the most out of your personal vaporization experience. Follow these steps to get your PAX 2 up and running:

Step 1: Pack the Oven

Remove the magnetic oven lid, located at the bottom of PAX 2, by gently pushing on one side and lifting it off. Finely grind your dry herb material and place it into the oven, which holds approximately .35 grams. Pack the oven firmly. If you wish to fill the oven with less material, visit the PAX website to purchase a Half-pack Oven Lid, which shrinks the oven capacity by about 50 percent.

Note: The PAX 2 only works with dry herb materials. Use the PAX 3 complete kit if you want to use your personal vaporizer to consume concentrates and dry herb.

Step 2: Select a Mouthpiece

PAX 2 comes with two mouthpieces constructed of food-grade silicone: a flat mouthpiece and an elevated mouthpiece. You can use whichever mouthpiece you prefer. Simply pull up the mouthpiece to remove and push down to replace. You can also purchase replacement PAX 2 mouthpieces in bright colors.

Step 3: Turn On the Device

Tucked away underneath the mouthpiece is the PAX 2 power button. Simply press down quickly on the center of the mouthpiece to turn on your device. Please note that PAX 2 will enter standby mode after approximately 30 seconds, and the device will automatically shut off after three minutes of non-use.

Step 4: Select a Temperature

PAX 2 has four predetermined temperature settings: 360°F (180°C), 380°F (193°C), 400°F (204°C), and 420°F (215°C). It takes approximately 45 seconds for the device to reach 400°F from room temperature.
To adjust the temperature setting, place PAX 2 into temperature set mode by pressing and holding the button until the LED indicator responds. Continue to short-press the power button to cycle through the four temperature settings:

  • One green petal – 360°F (180°C)
  • Two yellow petals – 380°F (193°C)
  • Three orange petals – 400°F (204°C)
  • Four red petals – 420°F (215°C)
  • Shake PAX 2 or long-press the power button to exit power mode.

Step 5: Draw

Place your lips around the mouthpiece and take a gentle “sip” from PAX 2. You can take longer and deeper draws as you get used to your dry herb vaporizer. PAX 2 begins to cool down once you are done drawing. This lip-sensing technology drops the temperature when you have not drawn from the personal vaporizer; this is to preserve your oven contents. The set temp immediately bounces back once the device returns to your lips.

How to Read the LED indicator

The LED light indicator on PAX 2 is made up of four petals in the shape of the PAX logo. This indicator communicates temperature settings, battery life, heating status, and more. Here’s a quick guide to understanding your LED indicator.

  • While heating: The petals will pulse purple while heating and turn to green when the desired temperature is reached.
  • While drawing: The petals will pulse green while the device is in use.
  • While adjusting the temperature: The four temperature settings are represented by one green petal, two yellow petals, three orange petals, and four red petals.
  • While in standby mode: All four petals will turn blue.
  • While checking the battery: The petals will turn white. Each petal corresponds to the estimated battery life, in 25-percent increments.
  • While charging: The LED indicator petals will pulse white as PAX 2 charges.

How to Charge the PAX 2

The PAX 2 battery lasts for up to 6 to 8 sessions per charge, depending on many factors. To recharge your PAX 2, connect the included USB charging cable to a USB power source. The magnetic cradle holds the device while charging. The lights will turn a solid white when PAX 2 is charged. The device reaches full battery in 2+ hours.
Shake the device to check the battery level. Consult the LED petals to determine the remaining battery life.

    • One white petal – under 25%
    • Two white petals – 25% – 50%
    • Three white petals – 50% – 75%
    • Four white petals – 75% – 100%

Cleaning & Maintenance

Clean your PAX 2 every few sessions for the best vaporization experience.

Keeping your PAX clean is easy. Remove the mouthpiece and oven lid, then dip a pipe cleaner in isopropyl alcohol and insert it into the vapor pathway. To clean, floss the pipe cleaner back and forth inside the device. The pipe cleaner will pop out the internal oven screen. We recommend cleaning the screen by placing it in a cup of isopropyl alcohol. The mouthpiece could be cleaned in the same way.

Never clean the oven lid in alcohol. If you’d like to clean the inside of the oven or sides of the mouthpiece, we suggest using a Q-tip. Carefully reinsert the screen so it is slightly bowed in the bottom of the oven, and press down gently to secure. Before you replace the screen and mouthpiece, make sure they’re completely dry. We recommend cleaning the device every few uses to optimize the experience.

Learn More About Your PAX 2

If you’re looking to learn more about your device, this Pax 2 review article has an in-depth how-to guide for all its personal vaporizers. For more information, visit the PAX 2 guide to read through the FAQ, watch an easy-to-follow video, view device specifications and materials, and much more. With this information in hand, you’ll continue to enjoy your PAX 2 for many sessions to come.

How to Use a PAX 2: Instructions, Tips, Details & More Read These PAX 2 Instructions Before Using Your Personal Vaporizer: The PAX 2 personal vaporizer is beloved for its sleek style and